Empire Comfort Systems pmn - Manual (Page 10)

Page 10 15627-4-0806
Figure 7
5. Align the 3/8" hole at the top of the leg with the 3/8" hole in
the leg pad. Attention: For proper positioning of the leg to
the leg pad the (2) 1-1/2" top edges of the leg must be placed
flush and parallel to the (2) edges on the leg pad. Attach leg
to leg pad by inserting (1) 1" bolt through the leg pad and
into the leg, secure bolt with 1/4" nut.
6. Insert (2) 3/8" bolts into the (2) holes on the edges of the
casting sides. The bolts should only be threaded half-way
into the holes in order to allow for clearance when the casting
back is attached to the casting sides.
7. Refer to Figure 7, the rear cover has (4) keyholes for attachment
to the casting sides. Stand the casting sides on the floor with
the (2) bolts attached half-way into the edges of the rear
cover positioned at the rear. The large diameter holes in the
keyholes of the rear cover will be toward the floor. Working
with one casting side at a time, place the large diameter holes
in the keyholes over and behind both of the bolts at the same
time. Push downward on the rear cover to lock the keyholes
into position behind the bolts. Finish tightening both bolts
to secure rear cover to casting side. Repeat this procedure to
secure rear cover to the second casting side.
Figure 6
ASSEMBLY OF STOVE CASTING