Empire Comfort Systems pmn - Manual (Page 19)

Page 19 15627-4-0806
Installation of Remote Receiver (Figure 20)
1. Attach, from left to right, the slide-on cover plate onto the
remote receiver. ON will be to the top and OFF will be to the
bottom on the slide-on cover plate.
2. Push the receiver slide button onto the receiver slide switch.
Reverse installation of the slide button if it is off center.
3. Attach velcro loop on the left side of the valve cover
support.
4. Attach velcro hook onto remote receiver. The word TOP on
the remote receiver should be to the top when installed onto
valve cover support.
5. Attach velcro hook on remote receiver onto velcro loop on
valve cover support.
Refer to remote control installation and operating instructions
for more details on remote control.
Figure 20
Wiring Diagram (Figure 21)
.
Figure 21
Maintenance & Service Instructions
IMPORTANT: Turn off gas before servicing appliance. It is
recommended that a competent service technician perform these
check-ups at the beginning of each heating season.
• DO NOT put anything around the heater that will obstruct
the flow of combustion and ventilation air. See clearances.
• DO examine venting system periodically. Clean and replace
damaged parts. Examinations should be made at the start
of the heating season and also in mid heating season under
average conditions.
• Clean Burner and Control Compartment
Keep the control compartment, logs, and burner areas surrounding
the logs clean by vacuuming or brushing at least twice a year.
Cleaning Procedure
1. Let the unit cool if it has been operating.
2. Shut off gas supply .
3. Lower valve cover on firebox.
4. Release two door latches at bottom of firebox.
5. Grasp bottom of glass frame, lift glass frame upward in order
to release glass frame from lip on top of firebox.
6. Vacuum burner compartment especially around orifice/primary
air openings.
7. Align and place top of glass frame over lip on top of firebox.
Grasp bottom of glass frame, push inward and place glass
frame onto firebox.
8. Attach two door latches to bottom of firebox.
9. Ignite pilot. (See Lighting Instructions)
10. Operate the main burner and visually check to make sure
the flame pattern appears similar to the pictorial illustration
shown for main burner flame pattern, Figure 18. If it appears
abnormal call a service person.
MAINTENANCE