Empire Comfort Systems pmn - Manual (Page 9)

Page 9 15627-4-0806
Figure 5
Assembly of Stove Casting (Figures 6, 7, 8, 9, 10, 11 and 12)
Attention: Included in the hardware package are (8) 1/4" inside
diameter washers. A 1/4" washer may be used with a 1/4-20 x 3/8"
bolt when assembling the stove casting parts. If a bolt hole is not
tapped deep enough for a tight fit between stove casting parts, the
1/4" washer can be used as a shim to provide a tight fit.
The 1/4" washers are not required for assembly of the stove casting
if all the bolt holes are tapped to a proper depth.
Additonal 1/4" washers are to be purchased locally.
1. Place porcelain casting pieces on a non-abrasive surface
in order to protect the porcelain finish. The exterior of the
porcelain casting pieces should be facing the non-abrasive
surface.
2. The assembly of the casting is accomplished in 7 stages:
A. Attaching legs to the sides (Figure 6).
B. Attaching rear cover to sides (Figure 7).
C. Removing protective packaging from casting front and
window (Figure 8).
D. Assembly of front by attaching retaining tabs and placing
front on unit (Figure 9).
E. Inserting firebox into partially completed assembly (Figure
10 and Figure 11).
F. Attaching firebox to rear cover (Figure 12).
G. Placing top on unit.
Detailed Instructions Follow
3. Refer to Figure 6, the leg pads will have the letter "A" and
"B" stamped into the metal. Place leg pad "A" and leg pad
"B" at the bottom of each casting side. Leg pad "A" attaches
to the front of the casting side, right and to the rear of the
casting side, left. Leg pad "B" attaches to the rear of the casting
side, right and to the front of the casting side, left. Position
the 3/4" flange on the leg pad against the (2) locator dimples
on the casting side. The 3/4" flange must be facing upward,
toward the top louver openings on the casting side. Attach
the two rear leg pads to the casting sides with (2) 3/8" bolts.
Attach but do not completely tighten the two front leg pads
to the casting sides with (2) 3/8" bolts. Attention: The front
leg pads can be adjusted to provide a snug fit between the
casting front and the casting sides.
4. Attach (4) leveling bolts to the bottom of the (4) legs.
APPLIANCE HARDWARE PACKAGE
ASSEMBLY OF STOVE CASTING
Appliance Hardware Package Parts List
Part
Description
Part
Number
Quantity
Supplied
1/42-0 x 1" Phillips Head Bolt R-3188 4
1/4-20 x 3/8" Phillips Head Bolt R-3646 16
1/4-20 x 1/2" Leveling Bolt R-3747 4
No. 10 x 1/2" Hex Washer Head Screw R-2737 10
1/4-20 Washer Head Nut R-3185 4
Leg Pad "A" (see Figure 6) CI-008 2
Leg Pad "B" (see Figure 6) CI-009 2
1-1/4" x 1/2" Retaining Tab (see Figure 8) CI-007 4
1/4" x 9/32 Washer (Not Shown) R-1150 8