Extron electronic MAV Plus - Manual (Page 35)

3-5 CrossPoint 450 Plus and MAV Plus Switchers • Operation
PRELIMINAR
Y
d
Preset button — The Preset button has two primary functions (•) and fi ve
secondary (
❏) functions:
• Activates Save Preset mode to save a confi guration as a preset and
Recall Preset mode to activate a previously-defi ned preset.
• Blinks when Save Preset mode is active and lights steadily when
Recall Preset mode is active.
❏ In the I/O Group mode, select group 2. See I/O grouping on page 3-20.
❏ In the I/O Group mode, indicate that group 2 is selected. See I/O grouping
on page 3-20.
❏ With the Enter, View, and Esc buttons, select Serial Port Confi guration
mode. See Selecting the rear panel Remote port protocol and baud rate on
page 3-42.
❏ Select 19200 baud for the RS-232/RS-422 port in Serial Port Confi guration
mode. See Selecting the rear panel Remote port protocol and baud rate on
page 3-42.
❏ Indicate that the RS-232/RS-422 port is set to 19200 baud in Serial Port
Confi guration mode. See Selecting the rear panel Remote port protocol and
baud rate on page 3-42.
e
View ( < ) button — The View ( < ) button has two primary functions (•) and
eight secondary (
❏) functions:
• Select View-Only mode that displays the current confi guration.
N View-only mode also provides a way to mute and unmute the outputs. See
Muting and unmuting video and/or audio outputs on page 3-29.
• Indicate that View-Only mode is active.
❏ In the I/O Group mode, select group 3. See I/O grouping on page 3-20.
❏ In the I/O Group mode, indicate that group 3 is selected. See I/O grouping
on page 3-20.
❏ (Systems with CrossPoint 450 Plus Wideband switcher BMEs) Decrease
the RGB delay of switches to the selected output. See Setting RGB delay
(systems with wideband BMEs) on page 3-24.
❏ (Systems with audio BMEs) Decrease the audio level of the selected
input. See Viewing and adjusting the input audio level (systems with audio
BMEs) on page 3-32.
❏ (Systems with audio BMEs) Decrease the volume of the selected output.
See Viewing and adjusting the output volume (systems with audio BMEs) on
page 3-35.
❏ With the Enter, Preset, and Esc buttons, select Serial Port Confi guration
mode. See Selecting the rear panel Remote port protocol and baud rate on
page 3-42.
❏ Select 38400 baud for the RS-232/RS-422 port in Serial Port Confi guration
mode. See Selecting the rear panel Remote port protocol and baud rate on
page 3-42.
❏ Indicate that the RS-232/RS-422 port is set to 38400 baud in Serial Port
Confi guration mode. See Selecting the rear panel Remote port protocol and
baud rate on page 3-42.