Preliminar y, Operation, cont’d – Extron electronic MAV Plus User Manual
Page 36
Operation, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Operation
3-6
PRELIMINAR
Y
f
Esc (
>
) button —
The Esc (
>
) button has two primary functions (•) and eight
secondary (
❏) functions:
•
Cancel operations or selections in progress and reset the front panel
button indicators.
N The Esc (
>
) button does not reset the current confi guration, the RGBHV
(CrossPoint 450 Plus switchers) or Video (MAV Plus video switchers) button
and Audio selection button, any presets, or any audio gain or attenuation or
volume settings.
•
Flashes once to indicate that the escape function has been activated.
❏ In
the
I/O Group mode, select group 4. See I/O grouping on page 3-20.
❏ In
the
I/O Group mode, indicate that group 4 is selected. See I/O grouping
on page 3-20.
❏ (Systems with CrossPoint 450 Plus Wideband switcher BMEs) Increase
the RGB delay of switches to the selected output. See Setting RGB delay
(systems with wideband BMEs) on page 3-24.
❏ (Systems with audio BMEs) Increase the audio level of the selected
input. See Viewing and adjusting the input audio level (systems with audio
BMEs) on page 3-32.
❏ (Systems with audio BMEs) Increase the volume of the selected output.
See Viewing and adjusting the output volume (systems with audio BMEs) on
page 3-35.
❏ With the Enter, Preset, and View buttons, select Serial Port Confi guration
mode. See Selecting the rear panel Remote port protocol and baud rate on
page 3-42.
❏ Select 115200 baud for the RS-232/RS-422 port in Serial Port Confi guration
mode. See Selecting the rear panel Remote port protocol and baud rate on
page 3-42.
❏ Indicate that the RS-232/RS-422 port is set to 115200 baud in Serial Port
Confi guration mode. See Selecting the rear panel Remote port protocol and
baud rate on page 3-42.