Epson AcuLaser C9200 Series - Manual (Page 15)

❏ Be careful not to touch the fuser, which is marked CAUTION HIGH TEMPERATURE, or the
surrounding areas. If the printer has been in use, the fuser and the surrounding areas may be very
hot. If you must touch one of these areas, wait 30 minutes to allow the heat to subside before
doing so.
*
*CAUTION HIGH TEMPERATURE
❏ Do not insert your hand deep into the fuser unit as some components are sharp and may cause
injury.
❏ Avoid touching the components inside the printer unless instructed to do so in this guide.
❏ Never force the printer’s components into place. Although the printer is designed to be sturdy,
rough handling can damage it.
❏ When handling a toner cartridge, always place it on a clean, smooth surface.
❏ Do not attempt to modify a toner cartridge or take it apart.
❏ Do not touch the toner. Keep the toner away from your eyes.
❏ Do not dispose of used toner cartridge or photoconductor unit in fire, as they can explode and
cause injury. Dispose of them according to local regulations.
❏ If toner is spilled, use a broom and dustpan or a damp cloth with soap and water to clean it up.
Because the fine particles can cause a fire or explosion if they come into contact with a spark, do
not use a vacuum cleaner.
❏ Wait at least one hour before using a toner cartridge after moving it from a cool to a warm
environment to prevent damage from condensation.
EPSON AcuLaser C9200 Series User's Guide
Safety Instructions 15