Epson AcuLaser C9200 Series - Manual (Page 96)

Item Settings (default in bold)
Form 5 …64… 128 lines
CR Function CR, CR+LF
LF Function LF, CR+LF
Tray Assign 4K, 5S, 4
*1 Available only when downloaded fonts are available.
*2 Depending on the font that has been selected.
FontSource
Sets the default font source.
Font Number
Sets the default font number for the default font source. The available number depends on the settings
you made.
Pitch
Specifies the default font pitch if the font is scalable and of fixed-pitch. You can select from 0.44 to
99.99
cpi (characters per inch), in 0.01-cpi increments. This item may not appear depending on the
Font Source or Font Number settings.
Height
Specifies the default font height if the font is scalable and proportional. You can select from 4.00 to
999.75
points, in 0.25-point increments. This item may not appear depending on the Font Source
or Font Number settings.
SymSet
Selects the default symbol set. If the font you selected in Font Source and Font Number is not available
in the new SymSet setting, the Font Source and the Font Number settings are automatically replaced
with the default value, IBM-US.
Form
EPSON AcuLaser C9200 Series User's Guide
Using the Control Panel 96