Epson AcuLaser C9200 Series - Manual (Page 88)

Item Settings (default in bold)
Skip Blank Page *3 Off, On
Auto Eject Page *4 Off, On
Size Ignore Off, On
Auto Cont Off, On
Page Protect *3 Auto, On
LCD Contrast 0 to 7 to 15
RAM Disk *1*5 Off, Normal, Maximum
*1 Available only when the corresponding option is installed.
*2 Available only when you use A4, A3, A5, B4, B5, LT, LGL, GLT, GLG, B, EXE, F4, or A3F size paper.
*3 Available only for ESC/Page, ESC/P2, FX, or I239X mode.
*4 Not available in PS3 and PCL.
*5 After this item is changed, the setting value takes effect after a warm boot or after the power is turned on again.
Language
Specifies the language displayed on the LCD panel and that printed on the status sheet.
Time to Sleep
Specifies the length of time until the printer enters the sleep mode if there are no button operations.
Time Out
Specifies the length of the time, in seconds, before a time out when interfaces are being switched
automatically. The time before a time out occurs is the length of time from the point when no data
is being received from an interface until the point of switching the interface. If the printer has a print
job when switching the interface, the printer prints the print job.
Paper Source
Specifies whether paper feeds into the printer from the MP tray, the standard paper cassette, or the
optional paper cassette unit.
If you select Auto, paper feeds from the paper source containing paper that matches your Paper Size
setting.
EPSON AcuLaser C9200 Series User's Guide
Using the Control Panel 88