Epson 4500 - Manual (Page 210)

Printing
Problem Solution
Printed characters are
not what you
expected.
The typestyle or
characters that are set
by the software cannot
be printed.
The Roman, Sans
Serif, or Draft font is
selected in your
software, but the
characters are printed
in a different font.
Italic characters are
printed instead of the
selected graphic “line”
characters.
The software may not be correctly installed
for your printer. Use the program’s setup
(or install) procedure to check the printer
settings, and reset as needed.
The wrong font is selected. If your
program accepts control codes, set the
codes to the values below to select the
built-in fonts:
Roman: ESC k 0
Sans Serif: ESC k 1
Draft: ESC x 0
See Chapter 3.
The wrong character table is selected. If
your application program is capable of
sending control codes, specify the Epson
Extended Graphics character table using
ESC t 1.
You can also select the graphics character
table by changing a DIP switch setting. To
do this, turn off the power, set DIP switch
1-7 to on, then turn on the printer. See
Chapter 3.
7-8
Troubleshooting