Epson 4500 - Manual (Page 227)

Options
Problem Solution
Using the cut sheet
feeder, the paper does
not feed properly
(continued).
After a print
command is sent from
the computer, the
platen rotates, but
paper does not feed.
The
PAPER OUT
light is
on.
DIP switch 1-8 is set to off. DIP switch
1-8
must be set to on in order to use the cut
sheet feeder. See Chapters 3 and 5.
The cut sheet feeder may be incorrectly
installed on the printer. Remove and
reinstall the cut sheet feeder making sure
that the mounting notches are properly
mated with the pins on the printer. See
Chapter 5.
The cut sheet feeder may be out of paper.
Load more paper in the cut sheet feeder’s
bin.
The paper release lever may not be in the
single-sheet position. Push the lever back
to the single-sheet position. See Chapter
5.
The paper set levers may be pulled
forward. After loading a stack of paper in
the cut sheet feeder, push the paper set
levers backward. See Chapter
5.
The left and right paper guides may be too
close together, preventing smooth paper
feed. Adjust the position of the paper
guides so that the paper can move up and
down freely. See Chapter 5.
Troubleshooting 7-25