Epson 4500 - Manual (Page 214)

Printing
Problem Solution
The print position is
not what you expected
(continued).
Page length does not
match the length of the
paper.
Regular gaps occur in
the printout.
Skip over perforation
is set, but the
perforation does not
fall in the center of the
skip.
Check the page length set by your
application software and adjust it if
necessary, or change the page length setting
with DIP switch 2-1.
If you are using the cut sheet feeder, the self
test function prints the number of printable
lines that can fit on a single sheet. Use this
feature to determine the correct page length
setting. See Chapter 3.
One-inch skip over perforation may be set.
Set DIP switch 2-3 to off, or use your
application program to cancel skip over
perforation. See Chapter 3.
The loading position of the paper may be
too high or too low. Use the micro-
adjustment feature to reset the loading
position so that the perforation is centered
within the skip area.
Your application program may be setting
the top and bottom margins. If this is the
case, turn off skip over perforation by
setting DIP switch 2-3 to off.
The page length for continuous paper may
be set incorrectly. Set DIP switch 2-1 to 11
or 12 inches. See Chapter 3.
7-12
Troubleshooting