Enterasys Networks D-Series - Manual (Page 122)

set lldp port tx-tlv
5-26 Discovery Protocol Configuration
Parameters
all Adds all optional TLVs to transmitted LLDPDUs.
port‐desc Port Description optional basic LLDP TLV. Value sent is ifDescr object
defined in RFC 2863.
sys‐name System Name optional basic LLDP TLV. Value sent is the
administratively assigned name for the system.
sys‐desc System Description optional basic LLDP TLV. Value sent is sysDescr
object defined in RFC 3418.
sys‐cap System Capabilities optional basic LLDP TLV. For a network
connectivity device, value sent can be bridge and/or router.
mgmt‐addr Management Address optional basic LLDP TLV. Value sent is IPv4
address of host interface.
vlan‐id Port VLAN ID IEEE 802.1 Extensions TLV. Value sent is port VLAN
ID (PVID).
stp Spanning Tree information defined by Protocol Identity IEEE 802.1
Extensions TLV. If STP is enabled on the port, value sent includes
version of protocol being used.
lacp LACP information defined by Protocol Identity IEEE 802.1
Extensions TLV. If LACP is enabled on the port, value sent includes
version of protocol being used.
gvrp GVRP information defined by Protocol Identity IEEE 802.1
Extensions TLV. If LACP is enabled on the port, value sent includes
version of protocol being used.
mac‐phy MAC‐PHY Configuration/Status IEEE 802.3 Extensions TLV. Value
sent includes the operational MAU type, duplex, and speed of the
port.
poe Power via MDI IEEE 802.3 Extensions TLV. Values sent include
whether pair selection can be controlled on port, and the power class
supplied by the port. Only valid for PoE‐enabled ports.
link‐aggr Link Aggregation IEEE 802.3 Extensions TLV. Values sent indicate
whether the link associated with this port can be aggregated,
whether it is currently aggregated, and if aggregated, the aggregated
port identifier.
max‐frame Maximum Frame Size IEEE 802.3 Extensions TLV. Value sent
indicates maximum frame size of the port’s MAC and PHY.
med‐cap LLDP‐MED Capabilities TLV.Value sent indicates the capabilities
(whether the device supports location information, extended power
via MDI) and Device Type (network connectivity device) of the
sending device.
med‐loc LLDP‐MED Location Identification TLV. Value sent is the ECS ELIN
value configured on the port.
med‐poe LLDP‐MED Extended Power via MDI TLV. Values sent include the
Power Limit (total power the port is capable of sourcing over a
maximum length cable) and the power priority configured on the
port. Only valid for PoE‐enabled ports.
port‐string Specifies the port or range of ports to be affected.