Enterasys Networks D-Series - Manual (Page 474)

show dot1x
17-12 Security Configuration
If port‐string is not specified, information for all ports will be displayed.
Mode
Switch command, read‐only.
Examples
This example shows how to display 802.1X status:
D2(su)->show dot1x
DOT1X is disabled.
This example shows how to display authentication diagnostics information for fe.1.1:
D2(su)->show dot1x auth-diag fe .1.1
Port : 1 Auth-Diag
Enter Connecting: 0
EAP Logoffs While Connecting: 0
Enter Authenticating: 0
Success While Authenticating 0
Timeouts While Authenticating: 0
Fails While Authenticating: 0
ReAuths While Authenticating: 0
EAP Starts While Authenticating: 0
EAP logoff While Authenticating: 0
Backend Responses: 0
Backend Access Challenges: 0
Backend Others Requests To Supp: 0
Backend NonNak Responses From: 0
Backend Auth Successes: 0
Backend Auth Fails: 0
This example shows how to display authentication statistics for fe.1.1:
D2(su)->show dot1x auth-stats fe .1.1
Port: 1 Auth-Stats
EAPOL Frames Rx: 0
EAPOL Frames Tx: 0
EAPOL Start Frames Rx: 0
EAPOL Logoff Frames Rx: 0
EAPOL RespId Frames Rx: 0
EAPOL Resp Frames Rx: 0
EAPOL Req Frames Tx: 0
EAP Length Error Frames Rx: 0
Last EAPOL Frame Version: 0
Last EAPOL Frame Source: 00:00:00:00:00:00
This example shows how to display the status of port reauthentication control for fe.1.1 through
fe.1.6:
D2(su)->show dot1x port reauth fe .1.1-6
Port 1: Port reauthenticate: FALSE
Port 2: Port reauthenticate: FALSE
Port 3: Port reauthenticate: FALSE
Port 4: Port reauthenticate: FALSE
Port 5: Port reauthenticate: FALSE
Port 6: Port reauthenticate: FALSE