Sleep and auto sleep, Sleep and auto sleep -19 – TA Triumph-Adler P-4030 MFP User Manual
Page 61
2-19
Installing and Setting up the Machine > Energy Saver function
Sleep and Auto Sleep
Sleep
To enter Sleep, press the [
Energy Saver
] key. Message display and all indicators on the operation panel will go out to
save a maximum amount of power except the [
Energy Saver
] indicator. This status is referred to as Sleep.
If print data is received during Sleep, the machine automatically wakes up and starts printing.
Also when fax data arrives while the machine is in Sleep Mode, the machine automatically wakes up and starts printing.
To resume, perform the following actions.
• Press any key on the operation panel.
The machine will be ready to operate within 15 seconds.
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time in the Low Power Mode.
The default preset time is 1 minute.
To change the preset sleep time, refer to
Follow the steps below to set the sleep timer for the machine to go into sleep mode when not in use.
1
Display the screen.
1
Press the [
System Menu/Counter
] key.
2
Press the [
▲
] or [
▼
] key to select [Common Settings], and press the [
OK
] key.
NOTE
If the Low Power Timer is equal to the Sleep Timer, a Sleep mode is preceded.
Energy Saver indicator
2
1
Sys. Menu/Count.:
User/Job Account
Exit
04
User Property
05
Common Settings
06