BenQ TH670s - Manual (Page 33)

Operation 33
Keep this manual in a safe place.
6. Confirm the new password by re-entering the new password.
7. You have successfully assigned a new password to the projector. Remember to
enter the new password next time the projector is started.
8. To leave the OSD menu, press MENU on the projector or remote control.
Disabling the password function
To disable password protection, go back to the System Setup: Advanced >
Password > Power On Lock menu and press OK on the projector or the remote
control. The message 'Input Password' displays. Enter the current password.
• If the password is correct, the OSD menu returns to the Power On Lock
with the highlight of Off.
• If the password is incorrect, the password error message displays lasting for
three seconds, and the message 'Input Password' displays for your retry.
You can press BACK
on the projector or remote control to cancel the
change or try another password.
Though the password function is disabled, you need to keep the old password in
hand should you ever need to re-activate the password function by entering the old
password.
Switching input signal
The projector can be connected to multiple devices at the same time. However, it can
only display one full screen at a time. When starting up, the projector automatically
searches for the available signals.
Be sure the Auto Source* function is On (which is the default of this projector) if
you want the projector to automatically search for the signals.
*You can set Auto Source function in the Basic menu when the projector is
without input signal or in the Advanced menu > System Setup: Basic menu.
You can also manually cycle through the available input signals.
1.
Press SOURCE on the projector or
remote control. A source selection bar
displays.