Hensel Certo 400 Monolight - Manual (Page 23)

Commissioning the device
23
Commissioning the device
To commission the device, proceed as follows:

Remove the transport cap (see page 24).

Dismantle the flash tube with protection glass (see page 26).
 Install the illuminant for the model light (see page 27).
 Mount the flash tube with protection glass (see page 26).

Mount the light shaping tool (see page 29).
 Connect the mains cable (see page 31).
 Turn on the device at the main switch (see page 36).

Trigger a test flash (see page 36).

Check the function of the model light (see page 37).