Hensel Certo 400 Monolight - Manual (Page 30)

Mounting and removing components of
the device
30
To mount the light shaping tool onto the device, proceed as follows:
 Press the lock (1) against the spring force to the limit stop.

Place the light shaping tool (3) on the device in such a manner that the
three mounting claws (2) are inside the light shaping tool (3).

Hold the light shaping tool (3) firmly while guiding the lock (1) into the
starting position using the spring force.
 Make sure the light shaping tool (3) is seated correctly.
To remove the light shaping tool, proceed as follows:

Hold the light shaping tool (3) firmly in one hand.
 With the other hand, press the lock (1) against the spring force to the
limit stop.
 Remove the light shaping tool (3) from the device and set it aside.

Guide the lock (1) into the starting position again using the spring force.