Hensel Certo 400 Monolight - Manual (Page 29)

Mounting and removing components of
the device
29
Mounting the light shaping tool on/removing it from the
device
WARNING
Heat is generated during the operation of the device.
Touching the device at the front can lead to severe burns.
 Always let the device cool down for 5 to 10 minutes
before mounting or removing components.
IMPORTANT!
When mounting or removing the light shaping tool on and
from the device, the protection glass can be damaged.

Do not touch the protection glass with the light shaping
tool.
 Make sure the device is held firmly when mounting and
removing the light shaping tool.
 When mounting the light shaping tool, place it evenly
onto the device.
 When mounting and removing the light shaping tool,
hold it firmly with one hand.