Hensel Certo 400 Monolight - Manual (Page 26)

Mounting and removing components of
the device
26
Installing and removing the flash tube with protection
glass
WARNING
Heat is generated during the operation of the device.
Touching the device at the front can lead to severe burns.
 Always let the device cool down for 5 to 10 minutes
before mounting or removing components.
To install the flash tube with protection glass (1), proceed as follows:
 Wear gloves according to EN 407.

Insert the pins (1) of the protection glass into the bushings (2) and press
the protection glass until it securely engages.
To remove the flash tube with protection glass (1), proceed as follows:

Remove the pins (1) of the protection glass from the bushings (2) with a
slight pull.