Hensel Certo 400 Monolight - Manual (Page 47)

Servicing the device
47
Replacing a defective model light
WARNING
Heat is generated during the operation of the device.
Touching the device at the front can lead to severe burns.

Always let the device cool down for 5 to 10 minutes
before mounting or removing components.
To replace a defective model light, proceed as follows:

Switch off the device at the main switch.
 Remove the mains cable (see page 31).
 Remove the light shaping tool (see page 29).

Dismantle the flash tube with protection glass (see page 26).

Replace the model light (see page 27).
 Mount the flash tube with protection glass (see page 26).
 Mount the light shaping tool (see page 29).

Connect the mains cable (see page 31).
 Switch on the device at the main switch.