Hensel Certo 400 Monolight - Manual (Page 27)

Mounting and removing components of
the device
27
Installing and removing the illuminant of the model light
WARNING
Heat is generated during the operation of the device.
Touching the device at the front can lead to severe burns.
 Always let the device cool down for 5 to 10 minutes
before mounting or removing components.
IMPORTANT!
When replacing or touching glass components with bare
hands, the glass bulb may become dirty and is therefore
unusable.

When touching or replacing the illuminant or flash tube,
wear gloves according to EN 407.
 After touching these components, always wipe them off
carefully.
To install the illuminant of the model light, proceed as follows:
 Make sure the device is switched off and disconnected from the mains.

Remove the illuminant (2) from the packaging.
 Make sure the illuminant (2) of the model light corresponds with the
local mains voltage.