Hensel Certo 400 Monolight - Manual (Page 43)

Error messages
43
Error messages
Problem Possible cause(s) Remedy
Device beeps –
temperature error
The model light turns
off, the fan runs at
maximum speed and the
device does not release
a flash. High ambient -
temperature at full
model light, unsuitable
light shaping tool,
covered ventilation slots
or defective fan.  Keep the device
switched on so that
the fan can cool down
the device.
 Make sure the
ventilation slots are
not covered.
 Make sure the fan is
not defective.
Display for the indication
of flash energy flashes The maximum recycling
time has been exceeded,
e.g. because the flash
tube has an afterglow.  Switch off the device
immediately.
 Send the device to
Customer Service.