VARI-LITE VL6000 Beam - Manual (Page 37)

I NSTALLATION : I NSTALLATION P ROCEDURES
2
02.9708.0002 27 April 2017 19
Installation Procedures
Installing Lamp
In the event the lamp was packed separately during shipment, follow the procedure in this section. For
lamp removal and replacement, refer to
“Lamp Removal and Installation” on page 72 .
WARNING: Disconnect fixture before relamping. Déconnectez le projecteur avant que le
changement de lampe.
CAUTIONS & WARNINGS
• Wear cotton gloves or other covering while installing lamp. Touching lamp glass with bare fingers
will leave oil and may cause the lamp to explode or reduce lamp life. If touched, use isopropyl
alcohol and cotton cloth to thoroughly clean glass portion of lamp.
• Hot Lamp. Luminaire must remain powered on for 5 minutes after dousing lamp. Do not open for
5 minutes after switching off. Lampe chaude. Le luminaire doit rester en marche pendant 5
minutes après avoir éteindre la lampe. Ne pas ouvrir pendant 5 minutes après la coupure.
• Risk of exposure to excessive ultraviolet radiation. Do not operate without complete lamp
enclosure in place or when lens is damaged. Risque d’exposition aux rayonnements ultraviolets
excessifs. Ne pas faire fonctionner sans le boîtier complet de lampe mis en place ou lorsque
l’objectif est endommagé.
To install lamp:
Step 1. Ensure power is completely removed from luminaire.
Step 2. Remove lamp from shipping box.
Step 3. Set the luminaire head horizontally.
Step 4. Engage tilt lock to secure luminaire head in position.
Step 5. At back of luminaire, using #2 Phillips screwdriver, remove lamp socket cover by loosening
the two quarter-turn captive screws. Note: lamp socket cover is connected with a safety
tether.
Figure 2-2: Lamp Socket Cover Removal
Lamp Socket Cover
Quarter-Turn Screws
Lamp
Lamp Socket