VARI-LITE VL6000 Beam - Manual (Page 94)

VARI ❋ LITE - VL6000 B EAM L UMINAIRE U SER ’ S M ANUAL
76 27 April 2017 02.9708.0002
Figure A-6: Align Gobo Flat to Carrier Flat
CAUTION: Wear protective gloves or other protective covering while handling gobos to avoid
leaving fingerprints. If dirty, clean with isopropyl alcohol and a soft, lint-free cloth.
Note: For the standard load of rotating gobos, refer to “Rotating Gobo Wheel 1” on page 36 or
“Rotating Gobo Wheel 1 - Standard Gobo Load” on page 37
Step 6. After gobo is installed, reinstall head cover(s).
Rotating Gobo Assembly
Rotating Gobo Wheel Assembly
Align gobo flat with carrier flat.
Gobo Glass Assembly Orientation
VERY IMPORTANT!
Side shown (to right) is the non-reflective side. The non-reflective
side must face the front lens.
Rear of gobo is the REFLECTIVE side and MUST be towards lamp.
VL6000 Beam Luminaires accept glass gobos only. Use of metal
gobos in these luminaires may damage gobo assembly and will void
the luminaire warranty.
LOGO
Rotating Gobo Assembly