VARI-LITE VL6000 Beam - Manual (Page 82)

VARI ❋ LITE - VL6000 B EAM L UMINAIRE U SER ’ S M ANUAL
64 27 April 2017 02.9708.0002
To set movement option:
Step 1. Press [ESC].
Step 2. Press [Up] / [Down] arrows until
Config appears. Press [OK].
Step 3. Press [Up] / [Down] arrows until Pan/Tilt appears. Press [OK].
Step 4. Movement will be displayed. Press [OK].
Step 5. Use [Up] / [Down] arrows to select Enable or Disable . Press OK] to select.
Diagnostic Tests
The following diagnostic tests are available in the test menu. Press [Menu] at anytime to stop test.
Test Descriptions
Test Name Display
ALL Test ................... Running 'ALL TEST'
Pan/Tilt ..................... Running 'PAN/TILT TEST'
Dimmer..................... Running 'DIMMER TEST'
Strobe....................... Running 'STROBE TEST'
Color Wheel 1 .......... Running 'COL WHL 1 TEST'
Color Wheel 2 .......... Running 'COL WHL 2 TEST'
Color Wheel 3 .......... Running 'COL WHL 3 TEST'
Gobo 1 ..................... Running 'GOBO 1 TEST'
Iris ............................ Running 'IRIS TEST'
Edge......................... Running 'EDGE TEST'
Frost ......................... Running 'FROST TEST'
USB Logging
The VL6000 Beam Luminaire stores error messages in a log file within the luminaire. This
information along with specific luminaire settings can be saved as a .csv
(comma-separated values)
file to a USB flash drive connected to the USB port.
To save the current log file to a USB Flash Drive:
Step 1. Insert a USB flash drive (not supplied, by others) into luminaire’s USB port.
Step 2. Press [ESC].
Step 3. Press [UP] / [DOWN] arrows until
Fixture appears. Press [OK].
Step 4. Press [UP] / [DOWN] arrows until USB appears. Press [OK].
Step 5. Press [UP] / [DOWN] arrows until USB Log appears. Press [OK].
Step 6. Press [UP] / [DOWN] arrows until DOWNLOAD appears. Press [OK].
Step 7. Once the download is complete, the display will read " Reset Current Lum error log
file? " Press [OK] to reset or [ESC] to exit.