VARI-LITE VL6000 Beam - Manual (Page 96)

VARI ❋ LITE - VL6000 B EAM L UMINAIRE U SER ’ S M ANUAL
78 27 April 2017 02.9708.0002
Figure A-7: Remove Parts for Cleaning
Once cleaning is complete, replace parts and screws in order as follows:
Step 1. Install the spider assembly and secondary reflector. One of the spider legs aligns with the V
in the logo at the center of the secondary reflector. The leg must install in the slot centered
between the yokes. See
Figure A-8 for correct alignment.
Spider Assembly with Secondary Reflector
6-32 3/8” PFZ Screw (x3)
Front Lens Assembly
6-32 3/8” PPZ SEMS Screw (x8)
Front Inlet Cover (x2)
6-32 3/8” PPB SEMS screw
6-32 3/8” PPB SEMS screw
Primary Reflector
Note:
Head covers not shown