Emulex NQTR0V-NATM - Manual (Page 129)

VAX/VMS DECnet LAT 5-1
Requirements
Before beginning, verify the network meets this requirement:
Clients must support the LAT protocol under the VAX/VMS (version 4.5 or
greater) or ULTRIX 32 operating systems.
NOTE: VAX/VMS is not supported on NETQue Token Ring
printer servers.
Before Installation
We recommend writing down the following parameters from the Setup
Section in Chapter 2. Refer to them during the installation procedure.
Default Server Name: ____ ____ ____ ____ ____ ____ ____ ____ ____
Default Printer Name: ___ ___ ___ ___ ___ ___ ___ ___ ___ _ ___
Circuit ID number __________
Port_n _______ (parallel port) Port_n_______ (parallel port)
Port_n _______ (serial port) Port_n _______ (serial port)
RCF port number _______
Printer Queues
The following is an example which can be used to set up each printer queue
on the host. Actual commands will vary according to system configuration,
type of printer, and application requirements.
NOTE: The start of a new command line is always
indicated by the prompt at the beginning. Some
commands wrap because of length but are intended
to be entered as one line.
1) Set up a printer queue and a VMS application port:
>
$ run sys$system:latcp
>
LATCP> create port lta901: /log