Emulex NQTR0V-NATM - Manual (Page 40)

2-20 Chapter 2
Print Configuration Parameters
Starting with software release 4.15, two methods can be used for printing
configuration parameters. The first method uses the status button, and the
second employs a software command.
Using Status Button
This procedure assumes that at least one printer is attached to the printer
server.
NOTE: If the printer is PCL or text only, the test printout
may contain Postscript commands.
1) Verify printer server has power.
2) Verify printer has power and is ON-LINE.
3) Momentarily depress the printer server status button.
If two printers are connected to the parallel ports, the printer server will
utilize the first available printer. If both printers are active with print
jobs, the status button is ignored.
Using Software Command
To obtain a printout of configuration parameters, enter this software
command:
>
Server>> show server config port port_num [ps]
port_num The output is directed to the specified port number.
ps Puts the output in PostScript format.