Emulex NQTR0V-NATM - Manual (Page 136)

AppleTalk 6-1
Requirements
Before beginning, verify the network conforms to these requirements:
• AppleTalk Phase 2
• System 6 or System 7
• LaserWriter driver 8.0 or newer
Before Installation
We recommend writing down the following parameters from the Setup
Section in Chapter 2. Refer to them during the installation procedure.
Default Server Name: ____ ____ ____ ____ ____ ____ ____ ____ ____
Default Printer Name: ___ ___ ___ ___ ___ ___ ___ ___ ___ _ ___
IP Address: ___ ___ ___-___ ___ ___ -___ ___ ___-___ ___ ___
Select Printer
NOTE: Verify the printer server is connected to the network
and printer. Power up the printer and printer
server.
From the A PPLE menu:
1) Click C HOOSER .
2) Select the L ASER W RITER or L ASER J ET icon.
3) Select the appropriate Zone, if available.
4) Select the Emulex default printer name.
See Before Installation section above.
5) Close C HOOSER .