Emulex NQTR0V-NATM - Manual (Page 194)

9-12 Chapter 9
2048 The printer server RCF port
3) Enter the password:
>
# access
where access is the default printer server remote login password.
NOTE: The password does not appear when typed.
4) Verify banner.
When the connection is made, the printer server login banner is
displayed.
5) At Enter Username or Help>, enter any two characters.
6) At Server>, enter su:
>
Server> su
This gives you supervisor status.
7) At Password>, enter system:
>
Password> system
where system is the default privileged password which does not echo
back.
8) At the Server>> prompt, view or change current parameters.
Refer to the list of commands in the Command Reference Guide.
9) Logout of the printer server:
>
Server>> logout
Local Login
1) Connect an ANSII compatible terminal or a PC running an ANSII
terminal emulation program to the printer server serial or console port.
Emulex default port configuration is set for 9600 bps, 8 data bits, no
parity, 1 stop bit, DTE type, with softcopy emulation.