Emulex NQTR0V-NATM - Manual (Page 105)

4-2 Chapter 4
* Pre-compiled binaries for these system types are included on the
distribution media, the distribution files do not need to be compiled during
ENSTALL.
NOTE: Check the file entitled PROGRAM NAME on the
UNIX Utilities diskette for the latest program
changes.
Before Installation
We recommend writing down the following parameters from the Setup
Section in Chapter 2. Refer to them during the installation procedure.
Default Server Name: ____ ____ ____ ____ ____ ____ ____ ____ ____
IP Address: ___ ___ ___-___ ___ ___ -___ ___ ___-___ ___ ___
Subnet Mask: ___ ___ ___-___ ___ ___ -___ ___ ___-___ ___ ___
TCP port _______ (parallel port) TCP port _______ (parallel port)
TCP port _______ (serial port) TCP port _______ (serial port)
Telnet port number _______ RCF port number _______
Automatic Installation
Emulex recommends running the ENSTALL utility. This user friendly
utility automatically configures the UNIX host to support network printing
via TCP/IP with Emulex printer servers.
CD ROM
1) Logon as root at the system prompt.
2) Change to a directory where third party software is typically installed.
For example, /usr
3) Insert the CD-ROM into a drive.
4) Extract the files from the cd-rom to the hard drive.
>
#tar xvf mount_point/utils/ps50/unix/50.tar ./emlx