Emulex NQTR0V-NATM - Manual (Page 107)

4-4 Chapter 4
When the ENSTALL utility begins, follow the instructions and supply the
requested information. When the ENSTALL program is complete, the
Emulex printer server is ready to use.
Manual Installation
IMPORTANT: This section contains advanced features.
All parameters should be configured by the
Network Administrator. Emulex
recommends running the ENSTALL
program instead of performing a manual
installation.
To manually install the printer server on a UNIX network:
• Assign the IP address using ARP, BootP, DHCP or RARP.
• Configure the print queue environment.
ARP
NOTE: ARP, PING and RARP commands do not alter the
subnet mask.
The ARP command offers a convenient means of assigning the printer
server’s initial IP address. The IP address is stored in the printer server’s
permanent and temporary memory. Although the ARP command is standard
on all UNIX platforms, its syntax may vary from one system to another.
Change IP Address
The ARP command cannot be used to change a printer server’s existing IP
address. To change an existing IP address, use telnet.
1) Logon to the printer server as supervisor.
2) Enter:
>
Server>> define server IP IP_address
IP_address The desired IP address in decimal dot notation.
3) Reboot the printer server.