Emulex NQTR0V-NATM - Manual (Page 98)

3-16 Chapter 3
12) At Password>, enter system:
>
Password> system
where system is the default privileged password which does not echo
back.
13) At the Server>> prompt, view or change current parameters.
Refer to the list of commands in the Command Reference Guide.
14) Log out of the printer server:
>
Server>> logout
15) Enter:
>
<Ctrl>
] C
Hold down the Ctrl key and press the right bracket key. Press C.
16) Exit Kermit:
>
C:\Kermit> exit
17) Display information about TES commands:
>
C:> tes help
Local Login
1) Connect an ANSII compatible terminal or a PC running an ANSII
terminal emulation program to the printer server serial or console port.
Emulex default port configuration is set for 9600 bps, 8 data bits, no
parity, 1 stop bit, DCE type, with softcopy emulation.
2) Press E SC twice.
This initiates communication between the console terminal and the
printer server serial port.
3) Verify banner.
When the connection is made, the printer server login banner is
displayed.
4) At Enter Username or Help>, enter any two characters.