HP V8.5 - Manual (Page 19)

I N S T A L L A T I O N
3
3-2 V8.5e Rev 2.2.2002
Inspect the plotter and components for any damage that may have
occurred during shipment. Report any damage to the carrier of the
shipment, and to your Imaging Systems Group Inc. product
representitive.
Keep the box and packaging for future shipping, in the event of
servicing or upgrading issues. This product must be returned to
our factory in the original or proper packaging material. Damage
caused during return shipping or due to improper packaging will
not be covered by The Imaging Systems Group Inc. During shipping
or storage, place a length of thermal paper between the printhead
and roller. This prevents damage caused by the two components
sticking together.
3.2 MOUNTING AND POSITIONING
Keep the V8.5e away from direct heat sources, including sunlight.
Do not block the vents on the sides of the plotter.
CAUTION: Make sure the thumbscrews are secured before operation.
This is particularly important in mobile situations. Damage to the plotter
or rack components could result if the plotter becomes unstable.
VORSICHT: Versichern Sie sich vor dem Betrieb des Gerätes, dass die
Flügelschrauben festgestellt sind. Das ist besonders in beweglichen
Konstellationen wichtig. Sollte der Plotter instabil werden, kann dies
zu Schäden am Plotter oder am Gestell führen.