HP V8.5 - Manual (Page 43)

O P E R A T I O N
4
4-16 V8.5e Rev 2.2.2002
Byte 10: line feed 0A
Example: To set the plotter to: contrast=C3
speed=1.0 ips
media=LP
scaling=S2
emulation=P3
formfeed=F2
bytes/scan=b1
grayscale media table=t1
Then send header: 99 13 21 31 43 53 61 71 81 0A
If the V8.5E accepts the setup string, the display will flash
If there are any errors in the string, such as an out of range value on
one of the numbers, or any other errors in the string format, the
plotter will not accept the string, no reconfiguration will take place,
and the error LED will flash twice.
4.4 ERROR MESSAGES
1. Media Out Error: The plotter will display a small square, flashing
segments and the error LED will flash. To fix this error, reload media
into the potter. Plotter must be put back online to continue plotting.
2. Hot Head Error: The plotter will display Ht and the error LED will
flash. The plotter will display this error until the thermal printhead
cools to a temperature that is safe to plot again.
3. 24 Volts Error: The plotter will display 24 and the error LED will
flash. If this error occurs, the 24 volt power supply may be faulty. Please
contact your product representative.
4. Thermistor Error: The plotter will display tH and the error LED will
flash. If the error occurs, the thermal printhead may be faulty. Please
contact your product representative.