HP V8.5 - Manual (Page 26)

3
I N S T A L L A T I O N
3-9 V8.5e Rev 2.2.2002
CAUTION: Before plotting or testing on any print media, make sure
that the media setting is correct. Incorrect settings may result in damage
to the printhead and warranty. The media may also be damaged.
VORSICHT: Bevor Sie mit dem Plotten oder Testdrucken auf einem
Druckmedium beginnen, versichern Sie sich, dass die Einstellungen
für das Druckmedium korrekt sind. Falsche Einstellungen können zu
einer Beschädigung des Druckkopfes und zum Verlust der Garantie
führen. Außerdem kann hierdurch auch das Druckmedium beschädigt
werden.
Installing rolled film
1. Loosen the rackmount thumbscrews and pull the plotter forward
on the rails.
2. Release the lid assembly by grasping underneath the black latch
bar and pulling it upwards (Figure 3-5). Open the plotter lid by
lifting it straight upwards.
2. Remove the fan-fold guide by grasping the two stainless steel
rails and lifting it straight upwards.
3. Place the spindle hubs onto each end of the roll of film with the
spacer on the left hand side spindle.
4. Orient the roll so that the film feeds off of the top of the roll.
5. Place the roll in the plotter so that the pins on the spindle hubs
snap into the slots on the spindle blocks.
6. Guide the film over the blue platen roller and under the black
cutter bar as shown in Figure 3-3.