Home Automation CAMERA SERVER 87A00-1 - Manual (Page 38)

5.4.2. Motion Detection Settings
After all of the settings have been entered for the Event Server, select the Motion tab to enter the
settings for the motion detection functions.
How to register Motion Detection
Step 1: Select a camera from the Image Source combo box and then press Play button.
Step 2: Select a layer from the Layer ID combo box.
Step 3: Check the Motion Enable checkbox.
Step 3: Right-click anywhere on the camera display to make an Area rectangle.
Step 4: Adjust the size of the Area rectangle by dragging the edges.
Step 5: Press SAVE and then RUN to test the motion detection settings.
You can set up to 3 layers. Each layer can have up to 8 areas.
The Object size and Sensitivity values of each Layer applies to all of the Areas on that Layer.
• Sensitivity – sensitivity of each macro block (16 x 16 pixels).
• ObjectSize – proportion of the exceeded Sensitivity of macro block in the respective Area.
Sensitivity and ObjectSize range from 1 to 255. A lower value means the higher sensitivity.
32