Honeywell ADEMCO LYNXR-EN - Manual (Page 24)

–24–
Data Field Descriptions
Other Programming Commands
✻55
ENABLING THE WIRELESS DIALER
Interactive menu mode used for enabling the 5842 Wireless Dialer. Refer to the
✻
55 Enabling the
Wireless Dialer Mode section for procedure.
✻56
ENHANCED ZONE PROGRAMMING MODE
Interactive menu mode used for programming zone attributes and report codes. Refer to the
✻
56
Enhanced Zone Programming Mode section for procedure.
✻80
DEVICE PROGRAMMING MENU MODE
Interactive menu mode for programming Powerline Carrier Devices. Refer to the
✻
80 Device
Programming Menu Mode section for detailed procedure.
✻81
ZONE LISTS FOR MENU MODE
Interactive menu mode for programming zone lists for Powerline Carrier Devices. Refer to the
✻
81
Zone List Menu Mode section for detailed procedure.
✻83 ENHANCED
SEQUENTIAL MODE
Interactive menu mode used to enter RF transmitter serial numbers. Refer to the
✻
83 Enhanced
Sequential Mode section for detailed procedure.
✻84
ASSIGN ZONE VOICE DESCRIPTORS
Interactive menu mode used to assign descriptors to each zone. These descriptors will be announced
whenever the system announces an event involving a zone.
✻85
RECORD CUSTOM VOICE DESCRIPTORS
Interactive menu mode used to record custom descriptors for use with each zone.
✻96
INITIALIZE DOWNLOAD ID AND SUBSCRIBER ACCT. NO. FOR
DOWNLOADING
Pressing
✻
96 initializes the system for downloading.
✻97
SET ALL PROGRAM FIELDS TO 1 OF 4 SETS OF DEFAULT VALUES
See Default Tables at the end of this manual.
✻98
EXITS PROGRAMMING MODE
Prevents re-entry by: Installer Code + 8 + 0 + 0; allows re-entry only by Power-up, then [
✻
] and [#].
✻99
EXITS PROGRAMMING MODE
Allows re-entry to program mode by: Installer Code + 8 + 0 + 0; or by Power-up, then [
✻
] and [#].