Honeywell ADEMCO LYNXR-EN - Manual (Page 26)

–26–
✻
55 Enabling the 5842 Wireless Dialer
While in Program mode, press ✻ 55 to enter Wireless Dialer Programming Feature.
The following explains the ✻ 55 prompts in detail. The left two columns identify the prompts and list the
available entries for each. The right-most column provides a further explanation of the entries.
Note: You may find it convenient to adjust the volume setting before entering the Programming Mode. This will allow you to clearly
hear feedback announcements or system beeps.
E
d
Enable the wireless dialer
[✻] = continue
0 = disable
1 = enable
Enter [1] to enable the 5842 Wireless dialer. Press [
✻
] to advance to next
field.
Enter [0] to exit mode. The prompt “55” blinks, indicating the mode is
inactive. Press [
✻
] + any field number to go to that field.
E
r
Enable trouble reports
[✻] = continue
[#] = return to previous prompt
0 = disable
1 = enable
If selected, the following 5842 trouble reports will be enabled:
• Loss of RF link with 5842 Wireless Dialer
• Tamper at 5842
• Low Battery at 5842
• AC loss at 5842 (if supported by the specific wireless dialer being
installed)
• Line Cut at 5842 (if supported by the specific wireless dialer being
installed)
Enter [1] to enable 5842 Wireless Dialer trouble reports. Press [
✻
] to
advance to next field or [#} to return to the previous prompt.
L
n
Response to phone line tamper
[✻] = continue
[#] = return to previous prompt
0 = enable trouble sounder
1 = enable alarm sounder
Select the Lynx response to detection of a line cut at the 5842 Wireless
Dialer.
If the trouble sounder is enabled the system will sound a trouble event any
time the 5842 phone line is cut.
If the alarm sounder is enabled the system will a trouble by day or an
alarm at night in the event that the 5842 phone line is cut.
Enter [1] to select alarm or [0] to select trouble in the event of a 5842 line
cut. Press [
✻
] to advance to next field or [#} to return to the previous
prompt.
Note: If an X-10 device has been programmed to ZT05 or ZT07 and
*55 has been enabled, the device response will be dependent upon
the selection made in *55 Field "Ln".
E
b
Enable back-up reporting
[✻] = continue
[#] = return to previous prompt
0 = disable
1 = enable
Allows Lynx to do back-up reporting for the 5842 wireless dialer. Enter [1]
to enable back-up reporting. Refer to the 5842 Wireless Dialer Installation
guide for additional information.
Enter [0] to disable back-up reporting. Enter [#} to return to the previous
prompt.
Note: Lynx must be connected to the premises phone line via the 5842
Wireless Dialer.