Ac power and backup battery, Ac power and rechargeable backup battery – Honeywell ADEMCO LYNXR-EN User Manual

Page 9

Advertising
background image

–9–

AC Power and Backup Battery

The system is powered by a 9VAC, 15VA Plug-in Transformer, ADEMCO 1332/1332X10 (1332CN in
Canada). Refer to the wiring table below for wire gauge and length.

Use only the provided ADEMCO
1332/1332X10 or 1332CN Transformer

Distance from Transformer

to Control

Wire Gauge

Up to 75 feet

#20

75 to 150 feet

#18

150 to 300 feet

#16

Wiring to the AC Transformer must not exceed 300 feet using 16-gauge wire. The voltage reading between
terminals 15 and 16 of the control must not fall below 9.00VAC.
Do not plug the transformer into the AC outlet until after all wiring connections have been made.

Backup battery. In the event of an AC power loss, the system is supported by a long life backup battery that
is supervised for connection and for low voltage conditions. If the battery is missing, or a low battery condition
is detected, a “low battery” message is displayed and a report is sent to the central station. In addition, the
system will beep once every 45 seconds to audibly indicate a low battery condition (press any key to stop the
beeping).


AC Power and Rechargeable Backup Battery

Connecting AC Power and backup battery

1. Connect wires from the 1332/1332X10 (1332CN in

Canada) AC Transformer to terminals 15 and 16 as
shown in the wiring diagram.

2. Remove battery retainer.

3. Peel the backing from tape on the back plate.

4. Insert battery pack into back plate.

5. Install battery retainer.

6. Connect battery connector to receptacle on

terminal block PC board.

7. After all wiring connections have been made, snap

the front assembly to the back plate and plug the
transformer into a 24-hour, 110VAC unswitched
outlet.

Note: Rechargeable batteries may take up to 48-hours to

fully charge. The “LOW BAT” message should clear

within four hours or by entering Test Mode.


01009-007-V0

1

BATTERY

RECEPTACLE

WIRING

TERMINALS

M

XXXX

K5108

TAPE

RETAINER

BATTERY

PACK

16

NOTE

LYNXRCHKIT-HC

BATTERY PACK SHOWN


Ensure the cover is snapped closed prior to applying AC power.

Advertising
This manual is related to the following products: