Panasonic KX-TD500 - Manual (Page 19)

Configuration
Programming Guide 19
1.5 VPS (DPT) Port Assignment
Used to assign parameters for VPS (DPT) ports. Up to eight Panasonic Voice Processing
Systems (VPSs) can be connected to the system.
How to set up a TVP
1. Assignment of the card which will be connected to the VPS System.
• When you use a new DLC / DHLC card and set up the TVP to the PBX:
Assign the card type of the slot to be installed to "DLC" or "DHLC" card and change the
card status to "INS (In-Service)" in "1-1 Slot Assignment" screen.
Then, see the information of "Card Properties" and confirm that the software version of
the card shows more than "1."
• When you connect the TVP to the existing DLC / DHLC : Go to step 2.
2. Assignment of the port which will be connected to the VPS System.
Change the attribute of the port to be connected to the TVP to "VPS (DPT)" in "1-3 Extension
Port Assignment" screen. When the attribute of the port is changed to "VPS (DPT)," the
parameters except "Attribute" will disappear and the directory number will be purged.
3. Assignment of VPS card and its model.
Select the corresponding equipment number in "TVP No." menu, the card (DLC / DHLC)
which connects with the TVP in "VPS Card" menu, and the model of TVP in "Type" menu in
"1-4 VPS (DPT) Port Assignment" screen.
4. Assignment of the extension port connected to the TVP.
Select in "Port No." menu the extension port number of the card (DLC / DHLC) to which the
TVP (DPT) jack is to be connected. This menu is displayed only when the attribute of the port
is assigned to "VPS (DPT)" at step 2.
After "Port No." selection, assign "DN" and "Extension Group No." for the port.