Hand Held Products 3080 - Manual (Page 46)

Programming the Scanner
3-32
Condensed Data Editor
♦ Preamble, Postamble, Data Length & Symbol ID Trans. ♦
PROGRAM END(Exit)
Family Code Selection Parameter Selection Option Code
Preamble None
1-15 characters (use hex value for each character)
Maximum 15-character input; scan “FIN” to terminate this selection.
FIN
[00-7F], [FIN]
Postamble None
1-15 characters (use hex value for each character)
Maximum 15-character input; scan “FIN” to terminate this selection.
FIN
[00-7F], [FIN]
Data Length Transmission Disable
Enable 2-digits data length transmission
If data length exceeds 99, 3-digit data length will be transmitted.
0
1
Code ID Transmission Disable Code ID transmission
Enable prefix Code ID transmission
Enable suffix Code ID transmission
Enable both prefix and suffix Code ID transmission 0
1
2
3
Data Pass Control Disable (format match required)
Enable (format match not required)
If data verifier is false, the original scanned bar code data will be transmitted.
0
1
The Data Editor is a very powerful, Artificial-Intelligence based data editing expert system provided specifically for the 3060B/3080B/3220 bar code scanners.
Through the Data Editor, you can process the scanned data prior to transmitting in many ways, such as: Insert, Delete, Match, Verify, Replace, Reorganize,
and Repeat Transmission. It also allows you to arrange the transmission of scanned data to any specific format.
Due to the resources used by this system, the Full-feature Data Editor is only supported by HHP SET. Through HHP SET, all settings and configurations can be
done on-screen, under Windows
® 95/98/NT environment.
A Condensed Version Data Editor is provided here in the manual and is utilized by scanning the programming bar codes.
When Data Pass Control is disabled, all input data must conform to an edited format or the scanner does not transmit the input data to the host.