Hand Held Products 3080 - Manual (Page 49)

Programming the Scanner
3-35
Condensed Data Editor
♦ Data Replacer Settings ♦
PROGRAM END(Exit)
Family Code Selection Parameter Selection Option Code 2nd Option Code
Replacer Control Disable
Select one bar code symbology
Select all bar code symbologies FIN
(2 digits)
00
automatic termination
automatic termination
1st Replacement Disable
Enable
2-digits identified position; 1 replacement character
FIN
(2-digit decimal
value)
position
[ 00-7F ]
2nd Replacement Disable
Enable
2-digits identified position; 1 replacement character
FIN
(2-digit decimal
value)
position
[ 00-7F ]
3rd Replacement Disable
Enable
2-digits identified position; 1 replacement character
FIN
(2-digit decimal
value)
position
[ 00-7F ]
FACTORY DEFAULT
The Data Replacer is used to edit the scanned raw data prior to transmitting the data to the host computers or terminals. It allows you to select desired bar code
symbologies for replacer control, and provides Multiple Position Replacement in the identified position.
All data must conform to the Identified Bar Code Symbologies, and one to three Identified Characters in the identified position. While the Data Replacer is
enabled, it arranges only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbology ID, or Record Suffix.
Please refer to page 3-37 for information about the “Bar Code Selection” and “Position Calculation” of Data Replacer.
To determine the hex value for the “Character,” refer to the HEX/ASCII Table listed on page A-6.
Refer to page 3-12 for 2-digit symbology option code.