Hand Held Products 3080 - Manual (Page 50)

Programming the Scanner
3-36
Condensed Data Editor
♦ Data Organizer Settings ♦
PROGRAM END(Exit)
Family Code Selection Parameter Selection Option Code 2nd Option Code
Organizer Control Disable
Select one bar code symbology
Select all bar code symbologies FIN
(2 digits)
00
automatic termination
automatic termination
1st Organization Disable
Enable
2-digits identified character position;
Transmit data before/after this position
FIN
(2-digit decimal
value)
position
Direction :
0 (Before)
1 (After)
2nd Organization Disable
Enable
2-digits identified position;
Transmit data before/after this position
FIN
(2-digit decimal
value)
position
Direction :
0 (Before)
1 (After)
Include/Exclude Control Transmitted data excluding the data of identified position
Transmitted data including the data of identified position 0
1
FACTORY DEFAULT
The Data Organizer is used to edit the scanned raw data prior to transmitting the data to the host computers or terminals. It allows you to select desired bar code
symbologies for organizer control, and provides a maximum of two identified positions to send the data before or after. It also allows you to control the transmitted
data including or excluding the data of the identified position. Please refer to the application example on the next page for details.
While the Data Organizer is enabled, it arranges only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbology ID, or
Record Suffix.
Please refer to the next page for information about the “Bar Code Selection” and “Position Calculation” of Data Organizer.
To determine the hex value for the “Character,” refer to the HEX/ASCII Table listed on page A-6.
Refer to page 3-12 for 2-digit symbology option code.