HP QMS 1660 User Manual
Page 179
Advertising
Optional
Network
Interfaces
6-41
Printer Options
4
Attach the NIC.
a
Position the NIC so the port slides into the opening you just
created.
b
Snap the plastic standoff onto the controller board.
c
Snap the NIC onto the 80-pin connector and the plastic
standoff, both on the controller board.
It’s okay to push down gently with your thumb positioned on
the NIC right over the connector.
5
Secure the NIC to the printer with the screws you removed
earlier.
6
Replace the controller board and printer covers.
Use the instructions in the “Replacing the Printer and Controller
Board Covers” section of this chapter.
7
Reconnect all interface cables and the power cord, and then
turn on the printer.
Advertising