HP QMS 1660 - Manual (Page 239)

Supported
DOC
Commands
C-3 Document Option Commands
Select original paper size%%IncludeFeature:size
Select pen width and color%%IncludeFeature:pen
Select plotter%%IncludeFeature:plotter
Shift the origin%%IncludeFeature:origin
Reverse image%%IncludeFeature:reverse
HP PCL 5 Emulation Commands
Enable scalable fonts%%IncludeFeature:scalablefonts*
Establish the current resource%%IncludeFeature:install*
and default object ID value
Remove an external object%%IncludeFeature:remove*
%%IncludeFeature:removeresource*
Reset to PCL defaults%%IncludeFeature:reset
Retain temporary macros/fonts%%IncludeFeature:retaintemporary
Select default font%%IncludeFeature:font*
Select default font ID%%IncludeFeature:fontid*
Select monochrome%%IncludeFeature:monochromegl
Select symbol set%%IncludeFeature:symbolset*
Set carriage return to CR+LF%%IncludeFeature:criscrlf*
Set linefeed to CR+LF%%IncludeFeature:lfiscrlf*
Set number of lines per inch%%IncludeFeature:linesperinch*
Set number of lines per page%%IncludeFeature:linesperpage*
Set point size%%IncludeFeature:pointsize*
Store fonts to disk%%IncludeFeature:resource*
* Indicates a DOC command about which updated information is pro-
vided in the following section, “Updated DOC Commands.”
Lineprinter Emulation Commands
Number lines%%IncludeFeature:number
Retain temporary macros/fonts%%IncludeFeature:retaintemporary
Select font for current job%%IncludeFeature:font
Set carriage return to CR+LF%%IncludeFeature:criscrlf
Set formfeed to CR+LF%%IncludeFeature:ffiscrlf
Set point size for current job%%IncludeFeature:pointsize
Set linefeed to CR+LF%%IncludeFeature:lfiscrlf
Set margins%%IncludeFeature:lpmargins