HP QMS 1660 - Manual (Page 40)

Configuration
Menu
QMS 1660 Print System Reference 4-8
Once you have changed the current input character, use the following
keys to move the cursor to another input character:
To exit from the character selection process, move the cursor to the
last character of the input field (the character farthest to the right) and
press the Select key, or move to the first character of the input field
(the character farthest to the left) and press the Menu key.
When you exit, the printer verifies the character information and con-
firms it in the message window. If the character information is valid,
you are returned to the previous menu; if it is invalid, you are returned
to the input field. Press the Menu key to cancel any changes to the
character information.
If the current character information is longer than the value that you
need to enter, replace each extra character with a space. The printer
interprets a space at the end of character information as a blank.
Example
To change the HP-GL emulation scaling percent, press the control
panel keys in the order shown in the following table. The printer
responds by displaying a status message or configuration menu in
the message window. An underline indicates the current input charac-
ter in the message window.
» Note: You may need to press the Next key more than one time to
advance through the list of selections or options.
Press this key... to...
Select Advance the cursor to the next character.
Menu Return the cursor to the previous character.
Press this
key... to... The message
window reads...
Online/
Offline Turn off the Online/Offline indicator and
readies the printer for configuration. IDLE
Menu Access the configuration menu. CONFIGURATION
OPERATOR CONTROL
Next Advance to the Administration menu. CONFIGURATION
ADMINISTRATION