HP QMS 1660 - Manual (Page 62)

Interfaces
QMS 1660 Print System Reference 4-30
▲ Caution: Before you install any optional fonts, ensure that the printer
has enough memory, or they may not all be available for use. If it
doesn’t, you can install SIMMs (see chapter 6, “Printer Options”) to
increase printer memory, or you can install a hard disk (see chapter 6,
“Printer Options”) and enable disk swapping (Administration/Memory/
Enable Disk Swap menu–see the “Memory” section, later in this
chapter).
Removing an Optional Font
Use the Administration/Disk Operations/Remove Option menu to
remove a previously installed optional font. See chapter 6, “Printer
Options,” for instructions.
» Note: If an error message displays in the message window during
this operation, press the Menu key to remove the message and
restart the operation from the beginning.
Interfaces
You can customize all of the printer’s interfaces through the Adminis-
tration/Communications menu.
Setting LocalTalk Interface Parameters
Use the Administration/Communications/LocalTalk menu to set the
LocalTalk interface values used for printer-host communication.
Mode
Enables or disables the communication interface.
Menu Administration/Communications/LocalTalk/Mode
Choices Enabled—Establish one-way LocalTalk communication from
the host to the printer).
Disabled—Turn off the LocalTalk interface, and the printer
stops accepting LocalTalk interface print jobs.