Hawking Technology H-BR49 - Manual (Page 11)

For CATV dynamic mode:
Adapter Address
Some Internet Service Providers (ISP) require that you
register the MAC address of your network card/adapter,
which was connected to your cable or DSL modem during
installation. If your ISPs require MAC address
registration, find your adapter’s MAC address by doing
the following:
Using Windows 95 or 98: Click Start Run; type in
“winipcfg”; select the network adapter (not PPP adapter).
Using Windows ME, 2000 or XP: Click Start Run; type
in “command”; press Enter. At the DOS prompt, type
“ipconfig/all”. Look for the Adapter’s “Physical
Address”: a 12-digit HEX number (00-11-22-aa-bb-cc).
Device/Computer
Name (or Host
Name by some
ISP.)
Enter a descriptive name for identification purposes. You
may have to check with your ISP to see if your Broadband
Internet service has been configured with a host and
domain name. In most cases, these fields may be left
blank. Some Internet Service Providers (ISP) require this
information and if that is the case, they will provide you
with the name.
Domain Name
Ex. yourcompany.com,
Provided by your ISP.