Hawking Technology H-BR49 - Manual (Page 52)

Factory Reset
To reset to factory default setting, click the reset button on the tool bar.
A warning message appears to advise you that you will lose your settings for the
device. Click OK to continue or Cancel to exit.
WAN IP
Displays the current Internet connection status. After the device is connected
to the Internet Service, you will see the IP, Subnet Mask, Gateway, DNS IP
addresses and Link Status on the table.
Connect: Click on this button to reconnect to the ISP and renew all IP
information on the WAN port.
Disconnect: Click on this button to disconnect from the ISP and release all
the IP information on the WAN port.
Figure 38